Condensing units
Compressors, condenser coils and fan motors, contactors and pressure controls on the outdoor or rooftop unit.
Walk-In Coolers & Freezers
Walk-In Cooler & Freezer Repair in Old Town & North Central Florida
A walk-in holds more product than anything else you own. When it drifts out of temperature, the clock is running on all of it.
We repair walk-in coolers and walk-in freezers for restaurants, stores and markets within 60+ miles of Old Town, Florida, 24 hours a day with no after-hours fee on emergency jobs. Most walk-in failures trace to the condensing unit, the evaporator and its defrost system, or the door, and we check all three before recommending a repair.
Overview
Walk-In Cooler and Freezer Repair for homes and businesses near Old Town, FL.
A walk-in is a refrigeration system built around a room: a condensing unit, usually outside or on the roof, feeds an evaporator coil and fans inside the box. Coolers normally run in the mid-to-upper 30s, safely below the 41°F cold-holding limit, while freezers run around 0°F and need a defrost system to keep the coil clear of ice. In North Central Florida the outdoor condensing unit works hard through the summer heat, and every time the door opens, humid air rushes in. That is why so many walk-in problems start at the door and the defrost system rather than the compressor.
When To Call
Signs you need walk-in cooler & freezer repair.
- The box is creeping above 41°F, or a freezer will not stay near 0°F
- The evaporator coil inside the box is caked in ice
- Ice building up on the freezer floor, ceiling or around the door
- The door will not seal, will not close on its own, or freezes shut
- Water leaking from the evaporator or pooling on the box floor
- The condensing unit outside runs nonstop, short cycles or trips the breaker
What's Included
What you get with walk-in cooler & freezer repair.
Evaporators and defrost
Evaporator fans, defrost heaters and controls, and heated drain lines that keep a freezer coil from turning into a block of ice.
Doors and box
Door gaskets, closers and hinges, heated door frames, and strip curtains that keep warm, humid air out of the box.
Our Process
How the job actually runs.
1. Save the product
On the phone: keep the door shut, move the most perishable items to a box that is holding, and note the current temperature.
2. Start at the box
Door seal, evaporator fans and coil condition are checked first, because they cause a large share of walk-in failures.
3. Test the condensing unit
Refrigerant pressures, electrical components and condenser airflow on the outdoor or rooftop unit.
4. Verify pull-down and defrost
We confirm the box pulls down to temperature and, on freezers, that defrost cycles and drains the way it should.
Pricing & Policies
What this costs, in plain terms.
These are our published policies. You get the price for your specific job before any work begins.
- On-site diagnostic service call: $95, credited toward approved work
- No after-hours fee on emergency jobs, including nights and weekends
- Repairs performed: one-year workmanship warranty
- Commercial maintenance plans available; plan customers receive 10% off service
40+Years in HVAC
Why All About Air and Heat
Straightforward service, guaranteed work.
- Walk-in coolers and walk-in freezers, indoor and outdoor boxes
- Condensing unit, evaporator, defrost and door problems diagnosed together
- 24/7 emergency service with no after-hours fees
- Licensed and insured — Florida license CAC1815820
Service Area
Walk-In Cooler & Freezer Repair across North Central Florida.
We serve homes and businesses within 60+ miles of Old Town, across Dixie, Levy, Gilchrist, Lafayette and Taylor counties and south to Sugarmill Woods in Citrus County.
Questions
Walk-In Cooler & Freezer Repair — common questions.
What temperature should a walk-in cooler and freezer hold?
Food held cold needs to stay at 41°F or below, so most walk-in coolers are set in the mid-to-upper 30s to give a margin. Walk-in freezers typically run around 0°F. If a cooler keeps drifting toward 41°F, call before it crosses it.
Why is the coil in my walk-in freezer a solid block of ice?
Almost always a defrost problem: a failed defrost heater, control or termination switch, or a frozen drain line that lets meltwater refreeze on the coil. A door seal letting humid air in makes it worse. The ice has to be cleared and the cause fixed, or it will come straight back.
Why is ice forming on the floor and around the door of my walk-in freezer?
Warm, humid air is getting in. The usual causes are a torn or flattened door gasket, a door closer that no longer pulls the door shut, or a failed heater in the door frame. In a Florida summer, even a small gap lets in a lot of moisture.
Should I repair my walk-in or replace it?
The insulated box itself usually lasts many years; most failures are in components that can be replaced: a compressor, fan motor, defrost part or door gasket. We give you the repair cost and an honest opinion on whether the refrigeration system is worth keeping before any work starts.
Related Services
More from All About Air and Heat Refrigeration.
Commercial Refrigeration
Refrigeration failures are not comfort problems. They are inventory problems, and they do not wait until Monday.
Learn moreReach-In Cooler & Freezer Repair
The reach-in on the line gets opened hundreds of times a shift, right next to the hottest equipment in the kitchen.
Learn moreDisplay Case Repair
A display case has to keep product cold and keep it visible. When the glass fogs or the top shelf warms up, customers notice first.
Learn moreIce Machine Repair
A bar or restaurant without ice is a business with a problem. We keep ice machines producing.
Learn moreNeed walk-in cooler & freezer repair? Let's get it handled.
24/7 service across 60+ miles around Old Town, with no after-hours fees on emergency jobs.